Installation Guide

Start
The START control (START/+30Sec. pad) begins
any function.
If cooking is interrupted by touching
the door, touching
START/+30S will resume the cycle.
Add 30 Seconds
The +30SEC control (START/+30Sec.) automatically
starts the
microwave oven at 100% power for 30
seconds, and adds
30 seconds of cook time with
each additional touch of the
control.
Express Cook
Each of the EXPRESS COOK controls (number pads
1-6)
automatically starts the microwave oven at 100%
power for
1 minute, 2 minutes, 3 minutes, 4 minutes,
5 minutes or
6 minutes, depending on which pad is
touched.
Stop/Cancel
and
pauses and/or cancels any program during
cooking. It will not
erase the time of day.
A cooking program may be paused by touching
once or by opening the door. The cycle may
be resumed by
touching START/+30Sec.
A cooking program may be canceled by touching
twice, or by opening the door and then
control is also used to lock and unlock
control panel. See “Control Lock” section.
Clock
This is a standard 12-hour clock (1:00-12:59). If
the clock is not
set, “0:00” will remain in the display.
When the clock is set, the “:”
will flash. During cooking,
the clock may be seen for 3 seconds
by touching
CLOCK.
To Set:
The microwave oven must be in standby mode (no
functions
operating).
1.
“00:00” will appear in the display, with the first “0”
flashing.
2. Enter current time, filling all four digits from left to
right. The
first digit can be only “1” or “0.”
3. Touch
Tones
Tones are audible signals that indicate the following:
One tone
Valid entry (short tone)
End of stage in multistage cooking
Control lock activated or deactivated (long tone)
Five tones
End of cycle
End of Kitchen Timer countdown
Kitchen Timer
The Kitchen Timer can be set in minutes and seconds,
up to
99 minutes, 99 seconds, and counts down the
set time. The
Kitchen Timer may not be used while
any other function is
operating.
NOTE: The Kitchen Timer does not start or stop the
microwav
e
oven.
To Set:
1. Touch TIMER control .
“00:00” will appear in the display, with the first “0”
flashing.
2. Enter desired time in minutes and seconds, filling all
four
digits from left to right. Example: 1-0-0-0 for 10
minutes, or
0-5-0-0 for 5 minutes.
3. Touch START/+30Sec.
When the set time ends, end-of-timer tones will sound,
and
the display will return to the time of day.
4.
to
cancel the Kitchen Timer.
Control Lock
The Control Lock shuts down the control panel pads
to avoid
unintended use of the microwave oven.
To Lock/Unlock Control: The microwave oven must
be in
for 3 seconds until
one long tone sounds and the
display clears to show an outline of
the display area.
Repeat to unlock control, and return the display
to
the time of day.
If any pad is touched while the
control is locked, there will be no
response from the
microwave oven.
1.
2.
3.
1.
2.
STOP or by opening
The STOP control clears any incorrect command,
STOP
touching STOP.
the
The STOP
Touch STOP at any time during the countdown
standby mode. Touch and hold STOP
Touch CLOCK control
STOP
EN-8
CLOCK.
ec.