Owner's Manual

13
technician. To prevent unnecessary risk of fire, electrical shock or personal injury, all wiring and grounding must
be done in accordance with the National Electrical Code ANSI/FNPA, No.70 Latest Revision and local codes and
ordinances. It is the personal responsibility of the appliance owner to provide adequate electrical service for this
appliance.
WARNING: NEVER connect the ground wire to plastic plumbing lines, gas lines, or hot water pipes.
Water
• To correctly fill your washer in the proper amount of time, water pressure of 14 to 70psi (100 to 500 kPa) is
required.
• Water pressure less than 14psi may cause water valve failure, or may not allow the water valve to shut off
completely, or may extend the fill time beyond what your washer controls allow, causing your washer to
turn off and alarm error.
• A time limit is built into the controls to prevent flooding in your home if a hose becomes loose.
• The water faucet must be within 4 feet / 122cm of the back of your washer to match the inlet hoses
provided with your washer.
• To avoid the possibility of water damage:
- Have water faucets easily accessible
- Turn off faucets when the washer is not in use.
- Periodically check that there is no leakage from the water inlet hose fittings.
Drain facility
• The recommended height of the standpipe is 35in. or 90cm.
• The drain hose must be routed through the drain hose clip to the standpipe.
• The standpipe must be large enough to accept the outside diameter of the drain hose.
INSTALLATION
Accessories Included
Figure 6
Figure 7
Bottom Cover
Pliers Phillip Screwdriver Level
Water Supply Hose Quick Connection Adaptor Screws
Tools Required