LISTED HEAT RECLAIMER 915U
Models MH-6 thru MH-8 Models MH-6-R thru MH-8-R The temperature of the flue gases shall be determined before installing the heat reclaimer.
1. Any flue or stove piping below Magic Heat must be 24 gauge metal or heavier to provide adequate supprt. Horizontal run of pipe must pitch upward toward the chimney at least 1/4 inch per foot of run.
(Not necessary for gas). well Units with serial numbers lower than serial # U 334 601 require annual oil service. Remove the back as described under “In Case of Power Failure” section. Then remove fan blade and six (6) screws that secure heat shield to back. Clean dust away from oil ports (See Figure 6) and oil motor with two (2) drops of SAE 20 light motor oil, one in each oil port.
Spot
Operate soot scraper at least daily for wood and coal burning and at least once a week for oil burning as a safety precaution against flue stoppage. Check stack vent yearly before each heating season begins. This should be done by a qualified gas heat serviceman.
MAGIC HEAT PARTS LIST 1) 2) 3) 4) 5) 6) 7) 7) * * 8 * 9) 9) * * * 10) 11) 12) 15) 22) MHSO** MHSI** MH-3 MH-12 MH-13 MH-l4 MH-15 MH-40G MH-16 MH-17 MH-18 MH-25 MH-31 MH-31G MH-32 MH-32G MH-34 MH-38 MH-41 MH-42F MH-77F Outer Case Assembly** Inner Case Assembly** Outer Back Motor Fan Cord (Electric) Thermostat (Wood, Coal, and Oil) Thermostat - Natural Gas Name Plate Sheet Metal Screws Brushing (Cord) Instructions Toggle Switch Switch - Natural Gas Indicator Plates Indicator Plates - Natural Gas Ground Wire
