Use and Care Manual

Installation

Hardware List

Table top

Table legs

8x16mm screw

Washer

Foot pad

spare 4x15mm Self-tapping screws

Hexagonal screw tap

8x16mm screw

Screw in the foot pad (the foot pad can be

used to adjust the balance when the ground

is uneven)

PAGE 1
Installation Hardware List Hardware List 1 2 Table top Table legs 16 4 Washer 8x16mm screw 6 Foot pad 10 spare 4x15mm Self-tapping screws 1 Hexagonal screw tap 1 Screw in the foot pad (the foot pad can be used to adjust the balance when the ground is uneven) 8x16mm screw
PAGE 2
4x15mm Self-tapping screws 8x16mm screw Place the table top on the ground horizontally and face down(note that the table top should not be in direct contact with the ground, cushion it with soft cloth), fix the support legs according to the instructions, turn it over and complete installation. This is a spare screw hole. When the 8x16mm screw fails to be screwed in, the hole can be fixed with a 4x15mm self-tapping screw. Either way will do.