Use and Care Manual

Installation

Hardware List

Table top

Table leg

Square beam

8x10mm screw

8x16mm screw and washer

spare 4x15mm Self-tapping screws

Hexagonal screw tap

Install the beams with

the legs, and then fix it

with 8x10mm screws.

（Note that the lugs on

the beams should face

upward）

Remove all the screws

off the legs.

PAGE 1
Installation Hardware List Hardware List 1 4 Table leg Table top 4 8x10mm screw 24 Square beam 8x16mm screw and washer 4 8 spare 4x15mm Self-tapping screws 1 Hexagonal screw tap 1 Remove all the screws off the legs. 2 Install the beams with the legs, and then fix it with 8x10mm screws.
PAGE 2
3 8x16mm screw and washer This is a spare screw hole. When the 8x16mm screw fails to be screwed in, the hole can be fixed with a 4x15mm self-tapping screw. Either way will do. Put the table top on the table leg, make sure the reserved screw holes of the table top and the frame are corresponding, tighten 8x16mm screws from the bottom to finish the installation. Adjustable foot pads at the bottom of the support legs.