SINGLE LEVER KITCHEN FAUCET Step Parts list Zz o PART NAME Shower hose Washer Spray Flexible hose Weight Screw Lock nut Gasket AWN Washer 10 Quick connector Body Deck Plate INSTALLATION INSTRUCTION SINGLE LEVER KITCHEN FAUCET
RECOMMENDED TOOLS The tools might be applied to the following places: Tools You Will Need: AS © LER EG Plumber's putty Pipe tape foothold future Philips Screwdriver pliers Adjustable wrench Allen key Notice: 1.Cleaning Before installation, shut off the water supply valves and clean up the water supply system. 2.Mounting hole = Make sure the mounting hole size is between (/33mm(35mm as show in the diagram. 3.Protection Clean the area of the mounting holes before installation.
Step Faucet installation Note:To make sure that the pull out hose go back semimonthly need ignore to adjust the weight in right position 1.Put the faucet into the installation hole. 2.Connect the shower hose to quick connect. Put the washer and gasket on the lock nut as Dis-assemble the weight and put is on the shown, then tighten with screws. shower hose. (Suggestion: diameter 35MM for installation hole) Then fix screws by screw driver.
Maintenance: temperate the faucet gently in order for a sustainable use. 2.Always blot dry any water from faucet surface.Clean with a damp non-abrasive sponge and wipe it with a clean soft cloth should be helpful to maintain good finish of the faucet. To remove water spots,apply warm water and a soft cloth.Make certain to rinse thoroughly with water immediately after cleaner. 3.Although the finish is extremely durable,it can be damaged by some cleaners.
Step Checking and testing Soh Sp C Note:Don't lost the O-ring filter. 1.Remove the shower by hand.Turn the faucet 2.Check all connections at arrows for leaks, handle all the way on,turn on hot and cold water re-tighten it if necessary. supply and flush water lines for one minute. Reinstall shower by hand.
