KITCHEN FAUCET Step Parts list Zz O PART NAME Body Washer Screw INSTALLATION INSTRUCTION Washer Gasket Lock nut Flexible hose Spray WOO Washer KITCHEN FAUCET
Tools You Will Need: ATS © Plumber's putty Pipe tape Philips Screwdriver pliers Adjustable wrench E : Notice: | 1.Cleaning Before installation, shut off the water supply valves and clean up the water supply system. | i 2.Mounting hole ) Make sure the mounting hole size is between £/33mmC/35mm as show in the diagram. 3.Protection Clean the area of the mounting holes before installation. To preserve the delicate finish of the faucet,please do not scratch, but use a soft cloth to wipe around it.
Step Faucet installation 1.At first, instill the washer in the groove of the 2.Put the faucet into the installation hole. bottom of the faucet, and then screw the lock nut (Suggestion: on it. Tighten the hot and cold hose with the diameter 35MM for installation hole body of the faucet. Put the washer and gasket on the lock nut as shown, then tighten with screws.
3.Connect the flexible hoses to water supply valve, and tighten it with adjustable wrench. Don’t over tighten avoiding damage the washer. «maintenance: temperate the faucet gently in order for a sustainable use. 2.Always blot dry any water from faucet surface.Clean with a damp non-abrasive sponge and wipe it with a clean soft cloth should be helpful to maintain good finish of the faucet. To remove water spots,apply warm water and a soft cloth.
Step Checking and testing Note:Don't lost the O-ring filter. 1. Turn on the hot and cold water for 1 minute in 2.Check all connection at arrows for leaks, order to check the outlet re-tighten it if necessary.
