Operating instructions

SET SATELLITE PROVIDER CODE
1. Press * 24 # to display the current service provider
(see chart on page 23).
2. To change the current service provider, press
* 96 #
* 66 #
* 88 #
3. Press the UP and DOWN arrows (2 and 8 keys) to choose your desired service provider from
the chart on page 23.
4. Press
* 25 # to lock in setting.
5. Turn unit OFF and back ON to save setting.
6. Press
* 24 # to display and verify code for new service provider.
7. Press OFF.
8. Unplug the Keypad and plug the controller back in.
9. Continue with RECEIVER CONFIGURATION below.
RECEIVER CONFIGURATION
DIRECTV Plus: 101/119
Set your receiver for oval dish-2 satellites (do this through the receiver’s satellite set-up
menu screens), and then go to page 30, OPERATION.
If you have an H23 receiver, choose the following dish configuration settings.
Dish Type: 02: 3-LNB (18”x20”), Switch Type: 02:Multiswitch.
For all of the following, go to page 27 and run the check switch.
Dish 500
Dish HD Eastern Arc
Dish HD Western Arc with Locals
Dish HD Eastern Arc with Locals
Dish HD Alternate with Locals
Bell TV Standard Digital 91
Bell TV HDTV 82/91
Bell TV HDTV 82/91 Alternate
Page 25