Operating instructions

2. Use Figs.10-11 on pages 13-14 to determine your desired wiring configuration.
TEMPORARILY connect system as outlined.
If using both 50’ coax, label the ends of one coax to avoid confusion when making the
connections.
MAKE SURE TO CONNECT POWER LAST.
3. Verify system operates properly as described in Section 4 OPERATION, Page 18.
DISH NETWORK - BELL TV: If configuring the receiver for multiple satellite switching, do
this now while the antenna unit is on a motionless platform (see page 25).
4. After verifying proper operation of the system, DISCONNECT POWER FIRST then all other
components.
DOME INSTALLATION AND EXTERNAL WIRING
IMPORTANT! USE ONLY THE COAX CABLES SUPPLIED WITH THE SEA-KING.
COIL AND STORE EXCESS CABLE IN THE CABINET WITH THE COMPONENTS.
DO NOT CUT COAX.
If coax cable other than that supplied with the Sea-King is used, the following guidelines must
be followed:
1) Ends must be terminated with SNAP-N-SEAL
®
connectors (Fig. 7.)
(DO NOT USE TWIST-ON OR HEX-CRIMPED CONNECT
ORS.)
2) Cable must be RG6 and rated at 2.2 GHz or higher.
Page 9
Fig. 7
IMPORTANT! Rubber O-rings must be REMOVED from ends of all SNAP-N-SEAL
®
connectors.