Operating instructions

6. When test is complete, a screen similar to
one of the following should appear:
(Screen graphics may vary.)
If indicated results are not obtained, go back to Step 1 and run test again. Contact King
Controls if the check switch fails to load after 4 attempts.
7. Save the settings, exit to the main menu screen and wait for your programming to download.
8. DISH 1000/1000a ONLY: Verify your saved settings show your desired satellite trio
(110, 119, 129 or 110, 119, 61.5).
Check switch is complete.
MUST SHOW
“SW21”
NO SWITCH DETECTED
or
INSTALLED DEVICE
UNKNOWN
NO “X”s
MUST SHOW
“SW64”
NO “X”s
DISH 500
ALL SINGLE SATELLITES
DISH 1000 DISH 1000a
BELL TV 82/91
Page 27