SDS

SAFETY
DATA
SHEET
Confirms to OSHA Hazard Communication Standard (CFR 29 1910.1200) HazCom 2012
Product:
Tub and Tile Refinishing Kit- Activator- 3124
Revision Date: 17-Jul-2019
Document No.: 130529-5 Page 3 of 5
Release Date: 1/10/2014
Environmental Precautions: See Section 12 for ecological information.
Methods and Material for Containment and Cleaning Up
Contain and/or absorb spill with inert material (e.g. sand, vermiculite), then place in a suitable container. Do not flush to
sewer or allow to enter waterways. Use appropriate Personal Protective Equipment (PPE). Scoop up material and place
in a disposal container. Provide ventilation.
SECTION 7 – HANDLING AND STORAGE
Handling: Keep away from sources of ignition- No smoking. Avoid contact with skin and eyes. Do not breathe
dust/fume/gas/mist/vapors/spray. Do not swallow. Handle and open container with care. Take precautionary measures
against static discharge. Use only non-sparking tools. When using do not eat, drink or smoke. Use only outdoors or in
well-ventilated area.
General Hygiene Advice: Launder contaminated clothing before use. Wash hands before eating, drinking, or smoking.
Conditions for Safe Storage, Including any Incompatibilities
Storage Conditions: Keep out of the reach of children. Keep container tightly closed. Store in a dry, cool and well-
ventilated area. Keep away from heat, sparks, and flame. Store locked up.
Incompatible Materials: Strong acids, strong bases, oxidizing agents.
SECTION 8 – EXPOSURE CONTROLS/PERSONAL PROTECTION
Control Parameters
Exposure Guidelines:
Chemical Name
ACGIH TLV
OSHA PEL
NIOSH IDLH
Bisphenol A diglycidyl either- bisphenol A copolymer
(25036-25-3)
Not available Not available Not available
Benzene, 1-chloro-4-(trifluoromethyl)- (98-56-6)
Not available
Not available
Not available
Propylene glycol monomethyl ether (107-98-2)
50 ppm
Not available
100 ppm
2-Butoxyehtanol (111-76-2)
20 ppm
240 mg/m
3
5 ppm
Dipropylene glycol monobutyl ether (34590-94-8)
100 ppm
600 mg/m
3
100 ppm
Toluene (108-88-3)
20 ppm
200 ppm
100 ppm
Appropriate Engineering Controls
Use ventilation adequate to keep exposures (airborne levels of dust, fume, vapor, etc.) below recommended exposure limits.
Individual Protection Measures
Respiratory Protection: In case of insufficient ventilation, wear suitable respiratory equipment. Respirator selection must
be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected
respirator.
Skin and Body Protection: Wear chemically resistant protective gloves.
Eye/Face Protection: Wear eye protection.
General Work/Hygienic Practices: Handle in accordance with good industrial hygiene and safety practice.
SECTION 9 – PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Liquid dispersion
Odor: Organic solvent
Odor threshold: Not determined.
pH: Not determined
Melting point/freezing point: Not determined
Initial boiling point and boiling range: Not determined
Flash point: 32ºC (90ºF) TCC
Evaporation rate: Not determined