Installation Instructions

PACKAGE CONTENTS
faucet and drain not included.
KEYPORT VANITY WITH TOP
INSTALLATION INSTRUCTIONS
Gray model: 30721
Matte white model: 30722
Dark chocolate model: 30723
Questions? Call our customer service department at
1-855-995-5578, 8:30 a.m. - 5 p.m., CST, Monday - Friday
or e-mail: [e-mail].
Base (x 1)
Top (x 1)
Adjustable shelf
(x 1)
Handle
(x 1)
24mm
screws (x 2)
Bumpers
(x 4)
Shelf
support pin
(x 4)
D
Tools required for assembly (not included):
• tape measure
• electric drill with #2 drill bit (A)
• level
• (x 2) #8 x 2” screws (B)
• (x 2) wall anchors - if the vanity will not be screwed to
wall studs (C)
• silicone (optional) (D)
Estimated installation time: 2-1/2 hours
(including removal of old vanity if applicable)
PREPARATION
OVERALL DIMENSIONS (INCLUDING TOP):
17-1/2”W x 34”H x 13-1/2”D
44.45 cm W x 86.36 cm H x 34.29 cm D
WARNINGS & CAUTIONS
WARNING:
Two people are required for safe installation. Take extra
precautionary measures to ensure a secure grip on the vanity
base and top when lifting.
CAUTION:
• The bathroom oor and wall must be nished prior to
installation of the vanity base and top.
• Do not use water that exceeds temperatures of 140°F/46°C.
• Do not place any sharp or abrasive objects on the bare surface
of the vanity top.
CARE & MAINTENANCE
• To maintain the beauty of the furniture nish, avoid placing
the vanity in direct sunlight.
• Avoid exposing the vanity to extreme temperatures by
installing away from heat and air vents.
• Dust frequently with a clean, soft and dry cloth.
• Wipe away any water or liquid spills on the vanity base
immediately with a clean, soft and dry cloth.
• Clean the vanity top only with non-abrasive cleaners or
mild detergents - do not use powder cleansers. For
extremely stubborn stains, use a small amount of
acetone on a cloth and gently rub out the stain.
1: Removing old vanity (if applicable): 1) Turn o󰀨 the water supply and take the
drain out. 2) Disconnect the supply lines from the faucet. 3) Remove the old
vanity top and vanity. Note: If the new vanity is not installed immediately,
temporarily stu󰀨 a rag into the drain pipe.
2: Using a level, locate any uneven oor and/or wall areas where your vanity will
be installed. Unevenness can cause your vanity to become misaligned resulting
in twisting of the cabinet. Repair any uneven areas by reducing high spots or
shimming low spots.
3: 1) Place the vanity in the desired position taking into account the location of your
plumbing. 2) Ensure the vanity is level front to back and at both sides.
4: Secure the vanity to the wall by inserting (x 2) #8 x 2” screws (B - not included)
through the back rail of the vanity. Figure 1. Note: It is recommended that the
vanity be installed to at least one wall stud. In order to locate wall studs, you can
use a stud nder or tap along the wall until you nd a spot that sounds solid. If
you are unable to locate wall studs, it is recommended that you use wall anchors
(C - not included) to secure the vanity.
INSTALLATION
Figure 1