Installation Instructions

SONATA VANITY BASES
MODELS 680, 684 & 673
.
INSTALLATION INSTRUCTIONS
Questions? Call our customer service department at 1-855-995-5578, 8:30 a.m. - 5 p.m., EST, Monday - Friday
or e-mail: [e-mail].
PACKAGE CONTENTS
OVERALL DIMENSIONS:
22-1/4 in. W x 17-1/2 in. D x 29 in. H
56.51 cm W x 44.45 cm D x 73.66 cm H
Model 680
Top and faucet not included.
Base (x 1)
Base (x 1)
OVERALL DIMENSIONS:
30-1/4 in. W x 17-1/2 in. D x 29 in. H
76.83 cm W x 44.45 cm D x 73.66 cm H
Model 684
Top and faucet not included.
Base (x 1)
OVERALL DIMENSIONS:
38-1/4 in. W x 17-1/2 in. D x 29 in. H
97.15 cm W x 44.45 cm D x 73.66 cm H
Model 673
Top and faucet not included.
Tools required for assembly (not included):
• tape measure
• electric drill with #2 drill bit (A)
• level
• (x 2) #8 x 2” screws (B)
• (x 2) wall anchors - if the vanity will not be
screwed to wall studs (C)
Estimated installation time: 2-1/2 hours
(including removal of old vanity if applicable)
PREPARATION
WARNINGS & CAUTIONS
WARNING:
Two people are required for safe
installation. Take extra precautionary
measures to ensure a secure grip on the
vanity base when lifting.
CAUTION:
The bathroom oor and wall must be
nished prior to installation of the vanity.
CARE & MAINTENANCE
• To maintain the beauty of the furniture
nish, avoid placing the vanity in direct
sunlight.
• Avoid exposing the vanity to extreme
temperatures by installing away from
heat and air vents.
• Dust frequently with a clean, soft and
dry cloth.
• Wipe away any water or liquid spills on
the vanity base immediately with a
clean, soft and dry cloth.
1: Removing old vanity (if applicable): 1) Turn off the water supply and
drain out. 2) Disconnect the supply lines from the faucet. 3) Remove the
old vanity top and vanity. If the new vanity is not installed immediately,
temporarily stuff a rag into the drain pipes.
2: Using a level, locate any uneven oor and/or wall areas where your
vanity will be installed. Unevenness can cause your vanity to become
misaligned resulting in twisting of the cabinet. Repair any uneven areas
by reducing high spots or shimming low spots.
3: 1) Place the vanity in the desired position taking into account the
location of your plumbing. 2) Ensure the vanity is level front to back and
at both sides.
4: Secure the vanity to the wall by inserting (x 2) #8 x 2” screws (B - not
included) through the back rail of the vanity. Figures 1a and 1b. It is
recommended that the vanity be installed to at least 1 wall stud. In order
INSTALLATION
Figure 1a: 22-1/4” base