Data Sheet

[e-mail]
www.magigoo.com
MAGIGOO
Thought3D Ltd, Unit2150, KBIC, Kordin Industrial Estate
Paola, PLA3000, Malta
Storage and Handling:
Magigoo-PPGF, should be stored in a cool dry place away from direct sunlight.
After use Magigoo-PPGF should be stored in an upright position and with the
cap on.
Excess Magigoo-PPGF on the nib can cause the applicator adhering to the
cap. To prevent this, make sure no excess Magigoo-PPGF remains on the rim
of the applicator after use.
If not capped the Magigoo-PPGF applicator will dry up. In such a case just
rinse with water.
2
An additional benefit of Magigoo-PPGF, being thermally activated, is that it
will release the print upon cooling. Again, different printers, print surfaces or
filaments will have slightly different release conditions but as a general rule a
reduction in temperature of 30-40 °C will be sufficient to remove your prints
without any effort.
Cleaning and re-applying between prints is recommended especially on
longer and/or more challenging prints.
Tips for challenging prints:
➡ After first layer of adhesive dries, apply second layer.
➡ Add a wide brim (20mm with 2 layers recommended).
➡ Increase nozzle temperature for first layer (10 °C) then drop to the
recommended temperature (filament manufacturer suggested).
➡ Increase bed temperature for first layer (5-10 °C) then drop to the
recommended temperature (filament manufacturer suggested).
➡ Increase first layer width and reduce first layer height.
➡ Enclosed printer is recommended.