Operation Manual

Start

Connection of camera

To supply your camera with power it must be connected

to the connecting cable of your vehicle´s reversing lights�

The camera is then activated every time the reverse gear is

selected�

Camera

Connector

Transmitter box

Antenna Red LED

Power cable

red

black

Reverse

lamp

cable splitter

Use the included 2 pieces of cable splitter to connect the red

camera cable to the positive cable of the reversing lights

and the black cable to the negative cable as shown on below

figure 1 - 3� The positive cable is normally colored, whilst

the negative cable is generally black� However, for absolute

certainty the correct cables should be determined by

measuring or checking with the manufacturer�

Fig. 1

Fig. 2

Fig. 3

Ensure that the cables are accurately connected and insulate

the connecting points to prevent bad contacts and short-

circuiting! Double check brake lights to ensure the lights

are still functional� If the camera turns on when braking, the

camera has been installed to the wrong source�