Operation Manual

5. Operation

5.1. Operating and indicating elements

The front of the receiver contains two indicating panels (K) and (L) and a button (M) for

changing the reception channels. The selected reception channel 1-4 is lit up in the indicating

panel (K). The left LED (very left on page) is reception

channel 1.

The automatic channel change function is active if

the LED of the small indicating panel (L) is lit.

By pressing the CH SELECT (M) button, the reception

channels 1-4 are selected in sequence after which the

automatic channel changing function is activated. By

pressing the button again, the automatic channel

changing function is switched oﬀ and reception

channel 1 is displayed again.

5.2. Automatic channel changing function

The radio monitoring facility can be extended by a further three cameras. Each camera must

transmit to another channel (1-4).

Note:

• The transmission frequencies of the surveillance camera and receiver have been

factory preset. The surveillance camera transmits on the frequency of one of the

available four reception channels of the receiver. After switch-on, the transmission

channel of the used surveillance camera must be selected on the receiver. The

transmission channel of the surveillance camera can be selected at the back of the

receiver.

(K)

(M)

(L)