Operation Manual

5.5. Setting the channel on the surveillance camera

Remove sealing cap (P) covering the camera’s channel changer.

Set the desired transmission channel (CH1, CH2, CH3 or CH4) by pushing both channel switches

(Q) into the respective position using a pin, as shown in the below illustration.

Then replace sealing cap (P) on channel changer and reconnect the power supply to the mains.

Note:

• When using several surveillance cameras ensure that each camera transmits on a

separate channel. As 4 channels are provided, a maximum of 4 surveillance cameras

can be connected. Even if only one camera is used, changing the transmission channel

may improve reception.

• Caution! Always disconnect power supply of camera from mains prior to changing

channel!

(P)

(Q)

Microphone