6.0

Song Settings and Preferences
282
(whose check box No Seq Trp in the track parameter box of
the Waveplayer window is checked).
Chase Notes on Cycle Jump: When activated, the chase
function will also chase notes, if a cycle jump occurs. This
parameter is only available when ‘Chase on Cycle Jump’ is
active.
Program Change: The last program change command
before the current play-start point is sent. Keep in mind
that a sound module will usually take a short while to re-
spond.
Pitch Bend Events: Pitch bend data are searched for.
Controller Events: If this switch is active, you can
switch three controller groups on and off individually:
Chase Control 0—15: Controller numbers 0—15 are
searched. These include the following controllers: modu-
lation wheel, breath, foot, volume, pan, portamento time,
balance and expression, plus the MSB for data entry and
bank select.
Chase Control 64—71: Switch controllers 64—71 are
searched. These include sustain, sostenuto, hold 2, soft
pedal and portamento.
Chase all other Controls: All other controller numbers are
searched.
Aftertouch or Channel Pressure Events: Aftertouch
data generated by the pressure sensor under the whole
keyboard is searched for. Aftertouch is also called „Chan-
nel Pressure“.
Polyphonic Key Pressure Events: Polyphonic After-
touch data, generated by pressure sensors under the indi-
vidual keys of is searched for.
System Exclusive Events: The last SysEx messages in
the sequences before the current play-start point are trans-
mitted. If the sequence contains the recorded data of a Sy-
sEx fader, the fader will be set to its correct state at the start
point.
Please keep in mind that chase events cannot always fully
restore the correct state of SysEx data at the start-play
point. To do so would involve not just searching for, but
also analyzing all SysEx messages in the whole song, both
before and after the play-start point. Because of the non-