6.0

Menu Effects
397
clipping behavior and this setting becomes an important
issue. Some DAT recorders have an analog protection
mechanism so that the level never reaches the digital
maximum signal. In these cases a setting of –0.5 dB or
lower make most sense.
By entering a value of –6 dB all samples above half of the
digital maximum are considered “distorted” and are
recalibrated. Even analog distorted material can be improved
with the algorithm.
Remove DC offset
This function in menu “Effects” removes a DC offset in
the selected range of a Wave project (RAP or HDP). Some
sound cards produce such a DC offset while recording, so
it is useful, if you can remove it!
Get Noise Sample (deLuxe version)
This mode uses a noise sample to reduce the unwanted
sound.
Noise Reduction (deLuxe version)
The Noise Reduction function can be used to effectively
remove annoying noise material from the audio with very
little or almost no discoloration of the original audio. For
this function the algorithm needs an example of the noise
print that needs to be removed. This function works best
with types of noises such as a constant occurrence of a
ground loop, air conditioner, hum, tape hiss or feedback.