15.0

is also possible in quantized draw mode.
Rubber-band tool
Use the rubber band tool to bend the pitch curves between
two neighboring handles.
Here the middle of the curve is moved while the curve handles remain the same. In combination with
moving the curve handles at the slice object edges, you can also move the pitch characteristic and attain
micro-tone structures (vibrato).
Cut tool
This can be used to split audio material manually into slice
objects (according to the notes).
If automatic recognition is not sufficient, then slice objects can be connected to one another using "Ctrl" +
the drawing pens.
Eraser
Use the eraser to reset the output value of the orange curve.
The pitch characteristic then corresponds to the original again and the curve corresponds to the
recognized curve.
Magnifying glass zoom tool
Zoom tool: Left mouse button "Zoom"
zooms in and the right mouse button zooms out.
Left-clicking and dragging can stretch out a range which can then be zoomed entirely.
Navigation tool
With the navigation tool, the visible clip can be moved
vertically and horizontally.
Applications of the Elastic Audio easy editor
Pitch correction (intonation correction) with monophonic audio material
Getting started (for all subsequent editing):

Load objects into the Elastic Audio easy editor.

Set the desired selection state. All slices are selected directly after the analysis.

Select suitable algorithms – you should test here to see if "monophonic voice" (see above) is the
suitable algorithm.

Now the pitch can be edited with the mouse tools by editing the orange curve or the pitch of the
slice objects.
Manual correction of the whole pitch of a pitch slice

Select the slice with the selection tool (arrow).

Move vertically with the mouse.
Automatic correction of the pitch characteristic

Select the slice objects with the selection tool (arrow).

Select the scale in the Edit slice objects group and, if required, deselect the tones which are not
to be quantized in the keyboard by clicking on them.

Press the "Tone pitch characteristics" button

With the parameter "Quantization smoothing" you can reduce the "strength" of the quantization.
In principle, this editing process more or less levels off pitch characteristics inside a slice.
Correction of the increase or decrease in the pitch.

Select the slice objects with the selection tool (arrow).

Click and drag the pitch curve by moving the two handles at each end of the slice objects or on
the orange lines.
Free redefinition of the pitch / Creation of frequency modulations like warblers and vibrato.
Page 222