15.0

Table Of Contents
Editing velocities and automation values
Hold down "Shift" and select any number of columns for velocity or automation with the mouse. Two
special commands are available for selection:
Shift + double click
Select everything in the bar clicked
on.
Shift + Ctrl + double click
Select all
The "Copy" button copies the selection to the clipboard. If you select this or that track in another editor,
then you can paste the notes there now from the clipboard. If the target selection is larger than the
contents of the clipboard, then it will be inserted again. This lets you quickly add a short section
throughout the complete length of the pattern.
The three handles allow the velocity or automation values to be edited together.
The middle handle increases or lowers the values together.
An object can be faded in or out with the handles to the left and right upper corners of the object.
If you move the handles horizontally you can change the curve shape of the transition.
A single click in the automation section cancels the selection again.
Note: A selection of velocity values matches the selection of corresponding notes in the matrix editor.
Page 488