15.0

Preparation: Setting the start marker and object end
Before opening the Auto Remix Assistant, you should set the start marker at the position in the song
object in the arranger where you want detection to start. If the song contains a long intro without beats,
set the start marker after the intro. As a rule of thumb, the Auto Remix Assistant should always be "fed"
dance music.

The start marker should be set before a quarter note beat or, better still, briefly before a beat at
the start of a bar.

If the start marker lies before the song object, the object is examined from the beginning.

If detection is not performed by the end of the song, the object can be shortened accordingly
with the object handle at the end of the object.
Checking the automatic tempo and bar recognition
After Ex opens, the selected track object will be analyzed. Following the analysis, the track will be
played, and during playback a metronome corresponding with the computed result will sound; vertical
tick marks visualize the quarter note positions in the wave form display.
The following is indicated:

Position of the start of the measure (one): red lines

Position of the other quarter notes (two, three or four): green lines

Reliably recognized positions: thick lines

Unreliably recognized positions: thin lines

Tapping is indicated by additional blue lines
If the tempo and beat information is already available, then dots above the display at the corresponding
positions will appear. To the left underneath the waveform display the metronome volume can be
adjusted. To the right the calculated BMP value will appear. If the BPM value is valid, the display will be
green.
If the metronome clicks match the rhythm of the music, the bar starts will then be determined. If not, you
can correct the tempo manually.
Page 807