2013

134
www.magix.com
settings when channels are changed. These are the gain presets for the different
playing styles within a song.
Voicing: We have provided Vandal SE pre-amps with something that we call Curve
EQ. For example, if you take a simple EQ pedal and shape the signal a little before the
amp, then this may change the sound quite drastically. Curve EQ does something
similar: It's located (in some cases multiply) at strategically important points between
individual amplifier stages and filters the signal, before it is distorted by the next
stage. Move the curve in both directions and navigate through the spectrum using the
"Freq" controller. This will give the amp a completely different character...
Equalization: The actual sound control (the "tone stack") functions rather
conventionally: Vandal SE offers low, mid & high settings. Everything functions like
the passive sound regulation network in genuine amps, so that the controllers
influence each other to produce numerous variations.
Reverb: Surf and twang simply need on-board spring reverb. We relied on well-known
reverb springs for modeling. Everything sounds natural with complete authenticity.
Bass amp
After roughly setting the Gain controller, the bass signal will first be treated with the
Contour circuit. This filtering stage works similarly to the "Loudness" function by
cutting the (lower) mids and lifting the deep bass and highs. It's sort of like an "instant
slap".
Next, the signal passes through the compressor stage (Comp). This is a simple but
extremely musical, visual design: The bass triggers a light source that is coupled with
a photo resistor which dampens the signal. This may already be familiar to you from
the most famous studio compressor for bassists, i.e. Urei LA2A, which functions
according to the same principle.