2013

136
www.magix.com
• Room reverb/hall reverb: Reverb offers realistic simulation of realistic
reverberation. Room creates the impression of a small to mid-sized recording
room, while Hall produces the sound impression of a concert hall. A particular is
that both effects algorithms provide a modulation parameter, which may remove
possible resonance at low dosages and can produce a soft chorus effect at higher
values.
• LoFi: This algorithm gives the sound a little bit of "grit", or a certain measure of
signal destruction depending on its setting. Turn down the internal sample rate as
much as you like to steal a few bits from the sound's resolution. This is definitely
unconventional...
• Vintage compressor: Ideal for thickening up the signal a little. The algorithm
emulates an older popular circuit design that is similar to studio legends like the
Urei 1176 or simple compressor pedals. A so-called "FET building block" controls
the volume via the input level simply, effectively, and quite musically, as well as
the set compression ratio and the attack and release.
• 3-band EQ: This sound controller works like a conventional mixer with controller
for bass, highs, and two controllers for the (variable) mids. This adds the final
polish to your sound.
Analogue Modelling Suite: AM-Track SE
am-track SE is a pure analog compressor simulation. The tape simulation contained in
the full version (Analog Modeling Suite am|track http://pro.magix.com/de/audio-
plug
ins/analogue-modelling-suite.175.html) isn't included. It is primarily used for so-
called "tracking", i.e. editing individual channel strips or subgroup signals. The
compression takes place in the "vintage" setting, whereas an additional "vca" setting
is available in the full version. The plug-in recognizes the number of incoming signals
and, if necessary, edits the signal in mono.
am|track SE limitations compared to the full version:
• No Tape simulation
• no "VCA" mode in the compressor, only "Vintage" operation can be implemented
along with the presets.