2013

File menu 337
Autoscroll/scrubbing: See "Playback parameters".
Stop at position: This stops the play cursor at the current position when the "Stop"
button is pressed and doesn't jump back to the original position.
Device: Specifies the driver of the sound card for playback.
Active: Checking this box activates Varipitch/Varispeed.
Varipitch/Varispeed mode
Vertical slider: This controller defines the playback from -200% to +200%, in which
case negative values cause the project to play in reverse.
Pitch: Double clicking this field enables the speed factor to be input directly, e.g. 0.5
for half speed, 2.0 for double speed.
Halftones: This field specifies pitch changes according to semitones; a value of -12
causes the project to play an octave lower at half speed, and a value of +12 plays back
the project one octave higher at double speed.
Internal rate: This specifies the sample rate for Varispeed calculation. At a sample
rate of 44,100 kHz, a value of 22,050 plays the project an octave lower at half the
speed.
BPM orig: Displays the original speed in BPM.
BPM out: Enter the target speed in BPM. Samplitude Music Studio 2013 calculates the
varispeed pitch factor from the quotient from the target to the original tempo.
MIDI settings
Here you can specify which MIDI devices (view page 453) to use in Samplitude
Music Studio 2013.
Synchronization
Opens the synchronisation dialog (view page 276). Here you can specify whether
Samplitude Music Studio 2013 should operate as master or slave, which protocol to
use, and which interface should be used to send or receive synchronization data.
Editing keyboard shortcuts and menus
Here you can open the dialog for Editing keyboard shortcuts, menu entries and mouse
functions (view page 465).
Edit toolbars
With this command you open the tool bar editor for the according toolbar. The same
function can be called by right clicking on the tool bar. All tool bars are customizable.
You can customize any toolbar by adding or removing any command, which is
available as a toolbar icon.