2013

436
www.magix.com
Sections
Samplitude Music Studio 2013 enables you to display one, two or three different
sections of a wave project or a virtual project.
In other audio programs, only one section of a project is usually shown. This is also
possible in Samplitude Music Studio 2013, of course. If you select the option "View >
Sections > 2", two project views, each of which can be worked in independently, open
one under the other. It is for example possible to view the complete project in one
section, while magnifying a certain area in the other.
The "3 (sections)" mode can be especially helpful when searching for loop points. The
upper large display shows the entire sample, while the two lower displays can be used
to zoom in for setting loop start and end.
If you wish to apply zoom commands to a section by using the position buttons
(position bar (view page 61)) for example, it is necessary to specify the section
bef
o
rehand for which the corresponding positioning is required. This happens by
clicking on the right or lower scroll bars of the section.
Hide submix / AUX buses
This function lets you hide or minimize the tracks of the mixer buses. Please read the
corresponding notes in the mixer chapter.
Grid view
Grid
This function gives the project a coordinates grid with valid units.
Shortcut: ´
Grid lines
Defines the type of grid used for the "Show grid" option. Choose from several line
styles.
Units of measurement
In this submenu, you can adjust the various measurement settings. They will affect
the start and length details of the current range in the project window, the grid
measurement, and the position details of the play cursor (position line).
Measurement units like samples, milliseconds, SMPTE (with different frame rates),
bars, and CD-MSF are commonly used.