Operation Manual

Insert object into the project 81
www.magix.com
eally
the preview images to check whether the found transition is r
a scene change or not.
Tip: This option is helpful, for example, if a camera flash was
captured in the source footage. The flash from the camera would
cause a sudden brightness modification even though there was no
actual scene change.
The preview always displays the end of the previous scene and the
beginning of the new scene. If the images do not differ except for the
brightness, then the scene may have been falsely recognized. In this
case select "Delete scene marker".
Via the zoom +/- buttons you can
enlarge the part of the arranger
where the selected scene begins or previous scene ended.
ttings.
"Action on OK" lets you specify whether the movie should be cut at
r
kes.
You can use the "Sensitivity" controller to change the sensitivity of
the scene recognition to detect different scene changes, depending
on the se
the selected scene transition or at all scene transitions and whethe
the found scenes should be saved as ta