Owner manual

1-800-MAGLINE (624-5463) Page 8 www.magliner.com

CooLift

User Controls

A) Main Power Switch – provides power to hydraulic unit for raising and lowering the deck.

B) Circuit Breaker – helps to protect the components should an electrical short or overload occur.

C) Charging Port – for charging the CooLift battery with an approved Magliner AC charger.

D) Deck Positioning Switch (up/down) – used to raise and lower the lift deck.

E) Brake Lever – used for slowing and stopping the momentum of the CooLift.

F) Holding Brake Latch – used to keep the CooLift from rolling inadvertently – Always engage

holding brake whenever CooLift is unattended.

G) Cord Storage Brackets – holds the AC built-in battery charger input cord when not in use.

H) Containment Strap – should be used to secure loads during transport.

I) Operator Handles – foam cushioned, ergonomic handles for lift control.

J) Manual Pump Handle – handle and storage bracket when not in use.

K) Manual Pump Handle Slot – for attaching manual pump handle in the event power is unavailable.

General Operation of the Magliner CooLift

Storage and Limited Use of Holding Brake

1) Engage the holding brake whenever leaving the CooLift unattended.

2) Pallets on the Magliner CooLift should always be in the down position when not moving.

3) Keep hands, feet and all items clear of the moving parts of the CooLift.

4) Never place hands or feet under a loaded elevated pallet.

5) The holding brake is intended to be used for limited periods of time only.

6) Store the CooLift on a hard level surface.

E F