User Manual

1-800-MAGLINE (624-5463) www.magliner.com
12
Pre-Trip Inspection
1. Before each use, check for damaged or missing components. Replace damaged or
missing components immediately with Magliner replacement parts.
2. Check all fasteners, and make sure to tighten or replace loose or missing hardware.
3. Check welds and material near welds for cracking or damage.
4. Make sure that pneumatic tires are properly inflated to 20-25 psi.
5. Unplug the charger from the hand truck by carefully pulling the connector out of the
charger port in the throttle. Install the dust cover boot over the plug connector on throttle
to keep the charger port clean. Store the charger in a dry, clean place.
6. Test the On/Off key switch to be sure the unit will turn on and off as intended.
7. Always check that the propulsion system is functioning properly before beginning the day;
with the unit On, test that the unit moves forward and backward with propulsion.
8. With the unit turned Off, release the park brake and push or pull the hand truck to make
sure it is functioning properly in manual mode. Then reengage the transaxle.