User Manual

1-800-MAGLINE (624-5463) www.magliner.com
13
Moving with Propulsion
1. To use propulsion, be sure that the motor’s brake lever is in the up position to engage
the transaxle.
2. Turn the unit On. Check to be sure surroundings are clear.
3. Pull the throttle lever toward you to move in reverse; push the throttle away from you
to move forward.
4. To increase the speed, push or pull the throttle lever further away from home
position.
5. To slow the unit, move the throttle lever closer to home position.
6. When you release the throttle lever, the unit will slowly come to a complete stop and
the park brake will engage.
7. The Hand Truck will slow to a stop and park in place even on an incline, as long as the
load on the hand truck does not exceed capacity.
Using the Motorized Hand Truck
On/Off Switch
1. Turn the rocker switch to ON position.
2. If the switch is left on for approximately 20 minutes without use, the controller goes into
a power save mode (sleep mode).
3. To wake the controller, cycle the rocker switch to the off position for 2 seconds, and then
back to the on position.
Variable Speed Control
Moving the throttle lever increases speed in proportion to how far you pull or push it – the
further you move away from home position, the faster you go forward or reverse. The
maximum speed is approximately 4.3 mph.
Releasing the lever will automatically return it to zero, commanding the controller to slow
down and stop the machine, locking it in place.
It is recommended operators set the High-Low speed switch to low when operating indoors
and/or when loaded. Operating in high speed mode is suggested only when the operator
has ample room to move and to stop, with few obstacles.
Reverse
Forward
On/Off
Switch