User Manual

STEP 2 – Determine System Voltage at Battery Pack Charge Port:
Motorized Dewar Cart – Remove Right Side Panel (standing behind the machine facing forward)
Motorized Hand Truck – Open Battery Pack Access Door
Take the battery box out of the machine, and connect the meter to the battery box charger port the
same way as you did on the throttle. Again, you should be reading 33 to 38 volts. If you are reading
33 to 38 volts, try recharging the battery pack off the machine for a few hours and retest. If the voltage
is rising, skip to step 3. If you are not reading any voltage (or the voltage is not rising after charging the
battery pack, then the control fuse may be blown. To check if it is blown:
1. Set your volt meter to Ohms (preferably it has an
audible indication which rin
gs to indic
ate zero
Ohms which
means the fuse is OK)
2. Connect black lead to Pin 1 of battery p
ack
charge port,
and red lead to termin
al 4 of the
grey connectors. If you g
et a ring, the
fuse is OK
and you can proceed to Step 3. If you do not get
a ring, the fu
se is bl
own and needs to be
replaced per
b
elow.
T
erminal 4
T
erminal 3
T
erminal 2
T
erminal 1
Magline, Inc. • 1205 West Cedar Street • Standish, MI 48658
Phone: [phone] • Fax [phone] • Toll Free (800) MAGLINE (624-5463)
www.magliner.com