User Manual

MEASURE CHARGER VOLTAGE

Make sure charger is NOT plugged into the wall outlet or

the machine.

Carefully attach the red lead from the volt meter to pin 1.

Then attach the black lead to pin 2. It is best to use

insulated alligator clips because if the red lead

(+40VDC touches the metal housing of the

charger port, it will short the charger and destroy

it.

Once the leads are securely in place, then plug in the

charger and measure the voltage. Anything less than 40-

volts indicates an issue with the charger. First check the

charger’s fuse, and replace if blown. If not blown and

intact, contact Magline.

PIN 1

PIN 2

PIN 3

CHARGER NOTES:

1. Never use a charger that has any visible damage to it such as broken or frayed wires or a broken housing.

2. The position of the on/off switch does not matter when charging.

3. To avoid corrosion around the charger pins, keep charger in a dry environment, and if necessary, apply

electrical-grade grease to pins.

4. Charger is not serviceable, so do not take it apart. Contact Magline for a replacement if the charger has failed.

5. For technical support, call Magline at 800-MAGLINE (624-5463)

RED ON PIN 1 BLACK ON PIN 2

Magline, Inc. • 1205 West Cedar Street • Standish, MI 48658

Phone: (989) 512.1000 • Fax (800) 968.7504 • Toll Free (800) MAGLINE (624-5463)