User Manual

1-800-MAGLINE (624-5463) www.magliner.com

Charging the Battery

The Motorized Hand Truck is provided with an off-board

V charger. To charge the machine, plug

one end of the charger into a

110

V wall outlet, and the other end into charger port. An LED light on

the charger will blink (or turn amber or red) while the unit is charging. When the unit is completely

charged, the light will turn solid green. For optimum performance, charge in temperatures from

50-

100

degrees F.

It is essential that the Motorized Hand Truck be kept on a charger whenever it is not in use; the

batteries will not overcharge. Before use, unplug the charger from the Motorized Hand Truck by

carefully pulling the connector out of the charger port in the throttle. Install the dust cover boot over

the plug connector on throttle to keep the charger port clean.

Charger port for

onboard charging

The batteries may also be charged separate from the machine (i.e. bench charging). Bench charging

is very useful if extra range is desired by having a second battery pack fully charged, or if the power

source is far from where the machine is stored. To charge using this method:

1. Open battery compartment door.

2. Remove pin.

3. Slide out the battery pack. PLEASE NOTE: The battery pack weighs approximately 38 lbs.

4. Insert the charger connector into the charge port on the battery pack to begin charging.

Step 1 Step 2

Step 3 Step 4