User Manual

1-800-MAGLINE (624-5463) www.magliner.com

Rear Stabilizer Arm

The rear stabilizer arm supports the hand truck in the incline position for ease of use.

The stabilizer arm has two positions – stowed and deployed. In the stowed position, the

stabilizer arm is folded up into the frame of the hand truck to minimize the overall footprint.

In the deployed position, the stabilizer arm is folded down so that the load is carried on the

two drive wheels and on the rear caster wheel as well.

Stowed Position Deployed Position

Stowed Position

Detent pin in stowed hole

Deployed Position

Detent pin in deployed hole

NEVER OPERATE UNIT

WITHOUT THE PIN SECURELY

PLACED IN EITHER HOLE

Deploying and Stowing the Stabilizer Arm

1. From a stowed position, pull the detent pin out of the stowed hole, and push the arm

downward until it is fully extended.

2. Align the detent pin and place into the deployed hole (you may have to move the arm up

and down slightly to align the pin through all three plates).

3. Make sure the detent pin is fully inserted with the safety clip properly secured BEFORE

putting any load on the stabilizer arm.

4. To stow the stabilizer arm, reverse the above process.

Deployed Angles