OWNER’S MANUAL For Models: A10-207 • A10-217 Stainless Steel Combination, Stove & Gas Grill ® U.S. PATENTS 4,788,962 5,330,154 5,414,090 D 292,163 Other Patents and Design Patents Pending For questions regarding performance, assembly, operation, parts, or returns, contact the experts at MAGMA by calling (562) 627-0500 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru Friday or e-mail us at mail@MagmaProducts.com Read these instructions carefully before use.
IMPORTANT SAFETY WARNINGS READ ALL INSTRUCTIONS BEFORE OPERATING. • USE OUTDOORS ONLY. • DO NOT USE THIS APPLIANCE INSIDE THE BOAT OR ANY ENCLOSED SPACE. • GRILLS RADIATE HEAT. CLEARANCE FROM COMBUSTIBLES, 24” SIDES AND BACK. NEVER USE UNDER AWNINGS, PATIO COVERS, ETC. • USE PROPANE GAS ONLY. FUEL STORAGE SHOULD BE IN COMPLIANCE WITH THE AMERICAN BOAT AND YACHT COUNCIL (ABYC) STANDARDS A-1 (9), MARINE LIQUIFIED PETROLEUM GAS (LPG) SYSTEMS. • FOR NATURAL GAS APPLICATION CONTACT MAGMA.
SETTING UP YOUR GRILL Mounts sold separately. See our website www.MagmaProducts.com for mounting options. Level Flat Surface 2 1 4 3 1 Select and install appropriate Magma mount in your desired location. Prior to installing the grill, check that mount does not easily move with a reasonable force applied. 2 Next, decide if gas control valve will be easier to access from the center right side or center left side of grill. This will be based on your placement of the mount (see picture front cover).
9 8a 8 7 7 Install radiant plate & dome over burner on fire pan ridge. 8 Install grill grate by rotating grate so that both grill grate tabs slide under the holding clips (8a), locking grate and all internal components in correct position. 9 Insert the turbo venturi tube into the threaded pipe on the bottom of the grill body and firmly tighten the threaded nut so nut doesn't turn while rotating the turbo venturi tube. Note: turbo venturi tube should still rotate freely.
USING GRILL WITH ON-BOARD LPG (PROPANE) SYSTEMS • Magma On-Board LPG (Propane) Valves & LPG (Propane) Low Pressure Gas Grill Connection Kit allow Magma Grills to be installed within a boats existing on-board, preregulated low pressure LPG (Propane) system. • Use only Magma Type 3 Low Pressure LPG (Propane) Valves. See our Valve Gently insert valve stem into venturi tube upside down until fully inserted & rotate as shown. Application Guide at www. MagmaProducts.com for correct valve. Typical Boat and R.V.
• Trim excess fats from meat. • Use non-oil based marinades. TO REDUCE FLARE-UP • Reduce heat. • Use water spray directly on flare-ups. To help create your own Magma gourmet experience every time you grill, please check these important critical points prior to lighting your grill. • • • • • • • • • • • • • • • • • Mount is secure and grill does not move. Grease tray & fire pan are clean from excess drippings to reduce flare up & ensure even air flow.
MAINTENANCE Complete Disassembly for Cleaning (or access to Piezo Igniter) 1 - Remove entire grill body from L-Bracket of Mount. 2 - Unthread and remove burner, fire pan and grease pan from outer bowl. 3 - To inspect piezo igniter, remove single screw from inside of outer bowl to release igniter box and carefully inspect for corrosion or loose wire connection. 4 - To reassemble, reverse above steps and steps 6 through 9 from page 3 “Setting Up Your Grill”.
REPLACEMENT PARTS A10-207 A10-217 Original Size Party Size 10-153 Cooking Grill 10-453 Cooking Grill 10-665 Radiant Plate & Dome 10-765 Radiant Plate & Dome 10-657 Burner 10-657 Burner 10-658 Fire Pan 10-758 Fire Pan 10-651 Complete Handle Assembly & Fasteners 10-651 Complete Handle Assembly & Fasteners 10-752 Lid w/hinge & fasteners (no handle) 10-652 Lid w/hinge & fasteners (no handle) 10-759 Outer Bowl 10-659 Outer Bowl 10-960 Piezo Igniter w/Wire Electrode & Screw 10-960 Piezo Igniter
TROUBLE SHOOTING GUIDE Problem Possible Cause Possible Solution Burner will not light with igniter Electrode covered with grease or residue Clean electrode Electrode not directly under burner ground strap Adjust burner so burner ground strap is directly above electrode Electrode wire loose, disconnected, or corroded Clean, adjust & reconnect wire between igniter & electrode, see “Complete Disassembly” (page 7) Wire is shorted causing spark from wire before electrode Replace Igniter, Electrode & W
ACCESSORIES Magma® Marine Kettle® Grill Cover/Tote Bag 10 Piece Stainless Steel Gourmet “Nesting” Cookware Magma Magic Grill Restorer Removes amber color from all Magma Grills - USA only LPG (Propane) Low Pressure Gas Grill Connection Kit for on-board LPG (Propane) systems North America Only Fish & Veggie Grill Tray Stainless Steel Finish or Coated with Teflon® Select Non-Stick Coatings Stores in less than 1/2 cubic foot 10 Piece Stainless Steel Gourmet “Nesting” Cookware Coated with Teflon® Select N