User's Manual

NOTE
Prior to installing the MAGMA CardBus Driver, you should be familia
r
with the installation procedures for the PCI cards that you are installing
in the expansion chassis. Some PCI card manufacturers recommend
that you install their software driver(s) prior to installing the hardware
.
If this is the case, you should install their driver before you connect and
power up the expansion chassis. You may be required to reboot before
connecting the expansion chassis.
NOTE
Under Windows XP, you MUST
connect the MAGMA expansion
chassis to your computer BEFORE installing the MAGMA CardBus
Driver.
MAGMA CardBus Drivers are required for Windows XP. Follow the
Step-by-Step Instructions included in Chapter Two: Quick Start Guide
prior to installing the MAGMA CardBus Driver. It is important to apply
power to the expansion chassis first, and then apply power to your
computer.
WARNING
You must be logged in as ‘System Administrator’ while installing the
MAGMA expansion chassis. You must remain logged in as ‘System
Administrator’ until installation Is complete.
The first time your system boots up, with the expansion chassis
connected, the following System Settings Change Window will appear:
WARNING
Although you have not installed the MAGMA CardBus Driver yet, it is
important that you answer ‘
Yes
’ to the above question and
restar
t
your computer
.
Click . Your computer will reboot.