User manual

Magma
Roben 3 | Chapter 2 Hardware Installation 47
2. Connect the other end of the cable to host computer via Host Interface card.
To Disconnect Ipass Cable
1. Pull the green tab while slowly pulling out the cable from the interface card.
2. Failure to do so can break the connector inside the interface card, which can cause the system to
malfunction.
Plug-in Power Cord
1. Connect the power cord to the power receptacle on the back of the unit.
2. Before connecting the power cord make sure to turn off the switch.
Powering on and powering off the unit
NOTE: Always turn on the chassis first prior to turning on the host computer.
To Turn ON:
1. Press the power supply Rocker switch to On position. The (I) symbol should be pressed down.
When the chassis power is on the unit is set to stand-by mode
2. Press the front On/Off switch to power up or turn on the Magma expansion chassis.
3. Once the expansion unit is turned on, you can turn on the Host computer.