Owners manual

-Carefully read all instructions before
installation-
Step 1: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 2: You will need to cut the OEM exhaust system
to remove it and to allow for the installation of the
new exhaust. Measure and cut 1.00" forward of the
Valve Assembly weld (shown in Fig.1) on the
passenger side pipe, and 4.00" on the driver side
pipe. Carefully remove the system from the vehicle
making sure to retain all mounting hardware as it will
be needed to install your new MAGNAFLOW system.
Step 3: Begin installing the new system. Attach the
two Inlet Pipes to the cut portion of the OEM system.
Use the supplied clamps to secure. Slip both Muffler
Assemblies over the Inlet Pipes using the supplied
clamps to secure. Make sure you locate the hangers
in the existing rubber insulators.
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15092
2011 Camaro A/B Street 6.2L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
03/29/11
Rev: 000
D/S MUFFLER
ASSY
P/S MUFFLER
ASSY
[4] 2.50" CLAMP
P/S INLET
PIPE
D/S INLET
PIPE
D/S VALVE ASSY
P/S VALVE ASSY
Fig.1