Owners manual

Step 1:(Carefully read all instructions before
installation) Unbolt the clamps at the inlet and
over-axle pipe, to remove the OEM exhaust system.
Disengage the welded hangers from the rubber
insulators and remove the components.
You may need to temporarily remove the
transmission skid plate to aid in removal and
installation. Retain rubber insulators as they will be
used in the installation of your new system.
Step 2: Begin installation of the new system by fitting
the Inlet Pipe Assembly to the catalytic converter,
fitting the hanger into the rubber insulator, and by
fastening it with the supplied 2.50 inch clamp. Be
sure to fit the alignment peg in the large notch and to
leave the clamp loose for final adjustment of the
complete system. install the Muffler, Extension and
Tail Pipe Assembly is a similar fashion leaving all
clamps loose for final adjustment
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). Inspect all fasteners after
25-50 miles of operation and retighten if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15238
2007 - 2011 Jeep Wrangler - 3.8L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
04/01/13
Rev: 000
INLET PIPE
ASSY
MUFFLER
ASSY
[4] 2.50" CLAMPS
EXTENSION PIPE
ASSY
TAIL PIPE
ASSY