Owners manual

BILL OF MATERIALS:

SHOP SUPPLIES:

MINIMUM REQUIRED TOOLS:

To ease removal of existing exhaust components

(especially on older vehicles) spray penetrating lubricant

on all fasteners and hangers/insulators that will be

loosened or removed and let soak before disassembly.

SPRAY LUBRICANT

WEAR SAFETY

GLASSES

READ INSTRUCTIONS

THOROUGHLY BEFORE

INSTALLING PRODUCT

MAGNAFLOW RECOMMENDS PROFESSIONAL INSTALLATION ON ALL THEIR PRODUCTS

WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle's

exhaust system to cool before removal, as exhaust system temperatures may cause severe burns. If working

without a lift always consult vehicle manual for correct lifting specifications. Always wear safety glasses and

ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

ATTENTION: Always install any supplied band or U-bolt clamps to the proper torque specifications of 40-45

ft-lbs for band clamps and 30-35 ft-lbs for U-bolt clamps. Over tightening will result in the clamp breaking and

will NOT be warranted by MagnaFlow.

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905

Technical Support: 1(800) 959-9226 | Email: moreinfo@magnaflow.com

18mm, 15mm, 13mm,

10mm, 8mm, 7mm,

#20 Torx

PART NO. 19173

2014-2015 CHEVROLET CORVETTE 6.2L

HARDWARE KIT:

1. [2] 3.00" Clamps

2. [4] 1/4" Hex Nuts

3. [4] 1/4"x.75" Hex Bolts

4. [4] 1/4" Lock Washers

1. INLET PIPE ASSEMBLY D/S

2. INLET PIPE ASSEMBLY P/S.

3. TAIL PIPE ASSEMBLY D/S

4. TAIL PIPE ASSEMBLY P/S

Hanger Tool

(Or Pry Bar)

19173 11/6/14 REV 000

PAGE 1
2014-2015 CHEVROLET CORVETTE 6.2L PART NO. 19173 BILL OF MATERIALS: 2 1 3 1. 2. 3. 4. 4 INLET PIPE ASSEMBLY D/S INLET PIPE ASSEMBLY P/S. TAIL PIPE ASSEMBLY D/S TAIL PIPE ASSEMBLY P/S HARDWARE KIT: 1. [2] 3.00" Clamps 2. [4] 1/4" Hex Nuts 3. [4] 1/4"x.75" Hex Bolts 4.
PAGE 2
Step 3. Next, remove the six 10mm bolts from the valence top. Carefully release the tabs on the top of the valence. The valence may now be removed. Step 1. To remove the OEM exhaust system you will first need to remove the rear valance. To do so you will need to remove The two 10mm bolts behind each reflector, the two 10mm bolts behind the license plate and two more 10mm bolts just underneath the license plate. Step 2.
PAGE 3
Step 8. Locate both OEM hanger brackets to each Tail Pipe Assembly. Next, loosely attach both assemblies to the Inlet Pipe Assembly outlets using the supplied 3.00" clamps. Using the supplied nuts, bolts and washers connect the two hanger brackets that will link both sides together. Reconnect each wiring harness connector the the valve motors. Reinstall the rear valence in the reverse order of the removal process. Step 6. Loosen both OEM clamps just rearward of the stock X-Pipe assembly.