Manual

Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15194
2013 Cadillac ATS 2.0L Turbo
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
06/18/13
Rev: 000
Step 1: (Carefully read all instructions
before installation. The OEM system will
need to be cut to allow for the installation of
the Magnaflow system ) Begin by cutting the
OEM system 7.25" from the rear of the catalytic
converter weld junction (see Fig.1). Next remove the
cross brace and beginning at the front of the vehicle
disengage the hangers from the rubber insulators (do
not discard or damage the OEM rubber insulators as
they will be reused to mount the new system) and
remove the system from the vehicle.
Step 2: Install the new Y-Pipe Assembly sliding it
onto the cut pipe exiting the catalytic converter and
engaging the hangers into the OEM rubber insulators.
Loosely fasten with a supplied 2.50" band
clamp(Leave all clamps loose for final adjustment of
the complete system). Install the Mid-Pipe and
Muffler Assemblies in a similar fashion using the
supplied 2.50" band clamps and OEM rubber
insulators.
Step 3: With all components mounted loosely,
adjust the system for overall aesthetics and clearance
of frame & bodywork. MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.
Step 4: Once a final position has been chosen for
the new system, evenly tighten all fasteners from
front to rear. The supplied band clamps must be
VERY tight to properly align the pipes and prevent
leaks (Approximately 40ft-lbs). Inspect all fasteners
after 25-50 miles of operation and retighten if
necessary.
Y-Pipe
Assy
D/S Mid-Pipe
Assy
P/S Mid-Pipe
Assy
Muffler
Assy
[5] 2.50"
Clamp