Owner's manual

Step 1: To remove your OEM exhaust system you
will need to loosen or remove the OEM clamp at
the outlet of the catalytic converter. Working front
to rear detach all hangers from the rubber
insulators. Retain the insulators and fasteners as
they will be used to install your new exhaust
system. Remove the system from the vehicle.
Step 2: Install your new MAGNAFLOW system
by first attaching the Inlet Pipe Assembly to the
catalytic converter outlet using the OEM clamp
fitting the hanger into the rubber insulator. Install
the Muffler Assembly by slipping it onto the the
Inlet Assembly and loosley secure with the
supplied Clamp. Install the Y-Pipe and Tailpipe
Assemblies in a similar fashion.
Step 3: With all components mounted loosely,
adjust the system for overall aesthetics and
clearance of frame & bodywork. (MAGNAFLOW
recommends at least 1/2" of clearance between the
exhaust system and any body panels to prevent
heat-related body damage or fire.)
Step 4: Once a final position has been chosen for
the new system, evenly tighten all fasteners from
front to rear. The supplied band clamps must be
VERY tight to properly align the pipes and prevent
leaks (Approximately 40ft-lbs). Inspect all fasteners
after 25-50 miles of operation and retighten if
necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15180
2013 Cadillac Escalade EXT/ESV 6.2L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Oct 26, 2012
Rev: 000
INLET PIPE ASSY.
MUFFLER ASSY.
Y-PIPE ASSY.
2X 3.50" CLAMPS
2X 2.50" CLAMPS
TAIL PIPE ASSY.
P/S
TAIL PIPE ASSY.
D/S

Summary of content (1 pages)