User Manual

NOTE: This scanner has 64MB of built-in memory for saving scanned

images. This lm scanner will also accept SD, SDHC, and SDHX cards with

a maximum of 128GB for extra memory. If you are using a 128GB SD card,

it may need to be formatted before using for the rst time. Please see

below for formatting instructions.

Using an SD Card

1. Insert the SD card, label up, into the SD card slot located at the

back of the lm scanner. The SD card will click in if inserted

properly.

2. Remove the SD card by pressing on it until it clicks and pops

out, then remove it from the slot.

1. In the Main Menu, go to FORMAT SD. Press the OK button.

2. When prompted if you would like to format the SD, use the

< button to choose “Yes”. Press the OK button to begin

formatting the SD card.

Formatting Your SD Card

WARNING: Formatting your SD card will delete all les stored on the

SD card. Download your les from your SD card to your computer

before formatting.

Scanning Your Images

1. Press the SCAN button to enter Capture mode.

2. You should now see your lm or slide image on the screen

and the corresponding lm/slide type is listed at the top

right corner.

NOTE: Image on screen does not reect scanned image quality.

3. To adjust Brightness or Color, press the OK button. Use the

left/right arrows to move between Brightness (EV), Red (R),

Green (G), or Blue (B). Press the OK button to adjust them

individually.

4. Once all settings are correct, press the SCAN button to return.