User`s guide

- 7 -
4. To stop the alarm press the ON / OFF button.
Alarm Duration and Snooze Function
The alarm will sound for 30 minutes if no key is pressed. It will shut off after 30 minutes
and wait until the next day at the same alarm time to sound again.
Snooze function
1. Once the alarm sounds, you can press the SNOOZE button on the unit to stop the
alarm.
2. The snooze interval is 9 minutes and the alarm will sounds again after this amount of
time.
3. To stop the snooze function and disable the alarm you press the ON / OFF button.
Changing Display Content
1. Press the YEAR button to display the current year, after 5 seconds the time will
appear on the display again.
2. Press the MONTH – DAY button to display the current month and day, after 5
seconds the time will appear on the display again.
Sleep Function
1. When the radio is on, press SLEEP button to turn on the sleep function.
2. The sleep time will flash for 5 seconds
3. During this time press the SLEEP button until your chosen time (90 – 15 min) is
displayed.
4. The radio will turn off after this time has elapsed.
Daylight Saving Time Function
1. Press the DST button and hold for 3 seconds to toggle on or off the daylight savings
time function.
2. The time will move forward or back one hour at 2 am that night.
Radio Operation
1. Press the ON / OFF button to turn the radio on.
2. Select the AM / FM BAND button to switch between AM or FM transmission.
3. Select your preferred station using the TUNING knob.
4. You can adjust the volume of the music by using the VOLUME knob.
5. Press the ON / OFF button to turn the radio off.
Note: The AM band uses an internal directional antenna, rotate the radio to improve
reception. For best FM reception, ensure the antenna is untied and fully extended.
Reset Function
The reset button is located on the back of the unit. Press this button with a pen or small
object when you replace the batteries in the clock, or the clock is not performing as
expected. You will lose any saved data like alarm times.
PROJECTION UNIT
1. Press the PROJECTION ON / OFF button on the side of the unit to turn the projection
on.
2. The projection will display the time on the wall or ceiling in a darkened room.