Owner`s manual

The cross-over frequency control should be set to the maximum value (200 Hz) when AV

receivers/amplifiers are used. The cross-over frequency between the subwoofer and

loudspeaker is then set in the receiver's/amplifier's set-up. Please refer to your

receiver's/amplifier's operating instructions here.

PHASE SWITCH (9)

In normal use the phase switch should be set to 0°. However, in rare cases it may be

advantageous to set the phase to 180° (e.g. if the subwoofer is far away from the front

satellites or in the event of unfavourable acoustics in the room). Generally speaking: the

setting where the lower base tone area has a fuller sound is the correct one.

FUSE (10)

Only use a fuse with the parameters indicated inside the triangle next to the fuse holder,

on the rear of the amplifier.

IMPORTANT SAFETY NOTICE

Never subject the subwoofer to dripping or splashing water. Do not place any flower vases

or other filled recipients on top of the subwoofer.

The distance between the active subwoofer enclosure and the walls of the room or other

objects (e. g. furniture, shelf units) may not be less than 5 cm on any side.

The aluminium plate and cooling fins of the amplifier at the rear of the active subwoofer

serve to cool the built-in amplifier; for this reason, they must also be at least 5 cm away

from all objects and must not be covered (e.g. by a curtain)

The bass reflex opening(s) on the active subwoofer must not be covered (e. g. by

curtains, etc.) in order to guarantee adequate ventilation of the amplifier.

Please do not place any items with naked flames (e.g. candles) on the active subwoofer.