Owner`s manual

Dear MAGNAT Customer,

The EDITION MONO car hi-fi power amplifier will enable you to satisfy your high demands on sound

reproduction in your car. With its impressive deep-bass power reserves, low harmonic content and neutral

reproduction, the EDITION MONO takes car hi-fi to new heights. The amplifier is characterized by low operating

current, rapid switching capabilities and excellent temperature stability. Experience and enjoy how this high-

tech machine perfectly reproduces magnificent sound.

Please read all of the owner’s manual before installing and using the amplifier.

1. TECHNICAL DATA EDITION MONO

Max. output power (1 kHz sinus burst 2:8, B+=14.4V) 800 W on 4 Ohm

Nominal output power (DIN 45 324, B+=14.4V) 225 W on 4 Ohm

Max. output power (1 kHz sinus burst 2:8, B+=14.4V) 1400 W on 2 Ohm

Nominal output power (DIN 45 324, B+=14.4V) 350 W on 2 Ohm

Loudspeaker impedance 2 – 8 Ohm

Frequency response 5 – 300 Hz (-3 dB)

Total harmonic content (DIN 45 403) < 0.08 % (1 kHz)

Weighted noise distance (IEC A) > 100 dB

Input sensitivity LOW LEVEL INPUT 0.4 – 4 V

Input impedance LOW LEVEL INPUT 20 kOhm

Low-pass filter 40 – 300 Hz, 12 dB per octave

Subsonic filter 10 – 40 Hz, 12 dB per octave

Bass boost 0…12 dB at 45 Hz

Supply +12 V (10 – 15 V), minus to ground

Fuse 2 x 25 A

Sizes (W x H x D) 345 x 57 x 236 mm

Weight 3.1 kg

SUBJECT TO TECHNICAL CHANGE

2. FEATURES

· Complementary push-pull final stage

· Stable at 2 ohms

· Low-pass (subwoofer) and subsonic filter with infinitely adjustable separating frequencies

· Infinitely variable bass equalisation

· Adjustable input sensitivity

· Electronic protective circuit against short circuiting, DC offset and excess temperature

· Mute switch for suppressing switch-on crackle interference

· Low-level outputs (cinch jacks) for connecting additional amplifiers

· Status indicator (green LED) and overload indicator (red LED)

· Remote control for volume control

3. IMPORTANT INSTALLATION INFORMATION

· This appliance may only be connected to a 12 volt system with negative ground.

· The heat radiated when the amplifier is used means that sufficient air circulation is required at the place

of installation. It is very important that the cooler’s cooler ribs do not contact any metal plating or any

surfaces which could impair air circulation. The amplifier may not be installed in small confined spaces or

spaces without air circulation (e.g. spare wheel recess or under the vehicle carpeting). Installation in the

boot is recommended.

· Install the amplifier in such a way that it is protected as far as possible against vibrations and dust and dirt.