Owner`s manual

Before you begin:
You must set Home in Location. ,,,J p.26
Otherwise, personalized picture and sound se_ings will not be
memorized after the unit goes into Standby mode.
1 Press MENU and use A T to select Sound, then press OK.
Before you begin:
Nake sure the unit isconnected to antenna or cable.
I Press MENU and use A Y to select Setup, then press OK.
_- Use A Y 411_ to select the item you want to adjust, then press
OK.
to select the desired setting, then press OK.
(Personal, Standard, Vivid, Sports, Movie, Music and
News)
Auto sound When you adjust the following settings (Equalizer,
SRSTruSurround XT and Auto volume leveling),
Persona w be set automatca
Adjust the tonal quality for each frequency.
Equalizer to adjust the each level of tonal quality
Press BACK to go backto the previous menu.
This selects sound modes for more spatial or surround sound
reproduction.
Off to set SRSTruSurround XT ®to Off
SRSTruSurround XT
On to set SRSTruSurround XT ®to On
This function keeps a constant loudness differential between theTV
commercials and the programs.
Off to remove the auto volume leveling
Auto volume
leveling On to reduce volume differences between
theTV commercials and the programs
You can select the Audio Output from the unit's speakers or not. If your
amplifier is HDMI link function compatible and connected by an HDNI
cable to this unit, some sound operations such as volume up can be
changed by using this unit's remote control. Nake sure fun-Link control
is set to On. ,,,,Jp.25
TVspeakers
to output sound from the unit's
speakers
On
Off not to output sound from the unit's
speakers
CEC Link
to control Audio Output from your
connected fun Link Compliant Devices
with VOL +/- by using this unit's
remote control.
You can set the output mode as a default for the sound mode (AnalogTV only).
This setting is not interlocked when you change the output mode by
pressing SAP. Refer to Switching audio mode. ,,,,j p. 14
Stereo to output stereo audio
Primary MTS Mono to output mono audio
SAP to output second audio program
_- Adjust the following items.
Autoprogram
Be sure the RF cable is correctly connected to this unit and you are
registered with your cable%/ provider when you install Cable channels.
1 Use A Y to select Autoprogram, then press OK.
, If you run Autoprogram when you have locked channels, a
message appears asking to enter your PIN. Enter your PIN in
order to complete the installation.You need to set the channel
lock again after the installation.
_- Use & Y to select an appropriate option, then press OK.
- When Antenna is selected, theTV detects antenna signals.
It searches for DTV and AnalogTV channels available in your
area.
- When Cableisselected,their/detectssignalssuppliedbycable.It
searchesforD_,AnalogTV and Cablechannelsavailableinyour
area.
Continued on next pa£e.