Owner`s manual

• When the scanning and memorizing are completed, the lowest
memorized channel will be displayed.
Add channels
This function lets you add the offthe air AnalogTV orAnalog Cable
channels that were not added by the autoprogram due to reception
conditions during the initial setting.
1 Use A Y to select Add channels,then press OK.
2 Use the NUMBER buttons to enter the number of the channel you
want to add, then press OK.
After setting Autoprogram, using CH +/- skips unavailable programs automa±ically.
ffyou are not receiving a signal fi-om your- cable service, contact the Cable provider:
ffyou press (I) or- MENU during autoprogram, the setup of TV channels will be
canceled,
Even ifAutoprogram is completed,the channel setting will be lost if the AC power
cord is unplug48ed before the unit goes into Standby mode by pressing (/).
The PiN Code will be required once you set a PiN code in the Child and ratings lock.
,_ p.22
ffyou want to change your PIN code, follow the instruction of Change PIN. ,_ p.24
Channel list
The channels selected here can be skipped when selecting the channels
using CH +/-.
Those channels can still be selected with the NUMBER buttons.
1 Use A Y to select Channel list, then press OK.
2 Use A Y to select the channel you want to remove,then press
OK.
• If setup completes successfully Added to the channel list. is displayed.
• if external Input is used, it is not possible to register the channel and Unavailable will be
displayed on theTV screen,
• Some channels cannot be selected by CH +/-. Use the NUMBER buttons to select
the memorised channels,
Antenna confirmation
This function lets you check the Digital signal strength of each channel.
1 Use A Y to select Antenna, then press OK.
2 Use the NUMBER buttons or CH +/- to select the channel for
which you want to check the Digital signal strength.
• The channel display for the removed channel darkens.You will
not be able to select the channel again using CH +/-.
• To reactivate a removed channel, use A T and press OK.The
registered channels are highlighted,
• When you remove a main channel, its subchanneis are removed
as well,
• The channel with DTV indica±ed on the display is ATSC. Otherwise the channel is
Analogm_
if the ciTannel is set to Analog channel or external input you cannot confirm the
antenna condition.