Manual

CAUIION
USE OF CONTROLS ORADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIRED HEREIN MAY RESULT IN HAZ4RDOUS RADIATION EXPOSURE.
The setcomplieswiththeFCC-Rules, Part 15and with21 CFR 1040.10.Operationissubjecttothe folio-
wing twocond#_ns:
I. Thisdevicemaynotcauseharmfulinterference, and
2.Thisdevice mustacceptanyinterferencereceived,includinginterferencethat may causeundesired
operation.
Canada
This digital apparatus does not exceed the Class B
linY_sfor radio noise emissions from digital apparatus
as set out in the Radio Interference Regulations of the
Canadian Department of Communications,
Cet appareil numedque n'emet pas de bruits
radioelectriques depassant les limites applicables dans
la reglement sur le brouiliage radloelectriques _.dicte par
le ministere des communications du Canada.
LASER
Type SemiconductorlaserGaAIAs
Wave lenght 775-795 nm (at 25°0)
Output Power 2,5 mW (Read)
35 mW (Write)
Beam divergence 60 degree
This warning label is located on the rearside and inside this laser product.
CAUTION: I*v_E_"_
LASERRADIATIO_t
WHEN OPEN, DO NOT STAI_ INTO BEAM
AVOIDDIRECTEXPOSURETO BEAM.
VARO! _ _'_su_._KJT'_uSBSB_;mT_SS_.U'XT ]
ALTTIINANAJ(YMMTOMAALLE LASE R,_I_TEILY l L E_ALA
KATSOSATEESEE,q.
0_YNUG LASERSTRALMINGNAR DENNADELAROPPNAO
VARNING, c¢_:_:s °_N_
or DANGER - Invisible laser radiation when open.
AVOID DIRECT EXPOSURE TO BEAM
NOTE
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to'part 15
of the FCC Rules.These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.This equipment generates, uses and
can be used in accordance with the instructions, may
cause harmful interference to radio communications.
However,[here is no guarenteethat interferencewilI not
occur in a particularinstallation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning this equipment off and on, the user is encouraged
to try to correct the interference by oneor more of the
following measures :
- reorientor relocate the receivingantenna.
- increasethe separation between the equipment and
receiver.
- connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- consult the dealer or an experienced radio/TV technician
for help.
IMPORTANT
THIS PRODUCT WAS FCC VERIFIED UNDER TEST CONDITIONS THAT INCLUDED USE OF SHIELDED CABLES AND
CONNECTORS BEWTEEN SYSTEM COMPONENTS. IT IS IMPORTANT THAT YOU USE SHIELDED CABLES TO REDUCE THE
POSSIBILITY OF CAUSING INTERFERENCE TO RADIOS, TELEVISION SETS AND OTHER ELECTRONIC DEVICES.
if YOU HAVEANY PROBLEMS CONTACT YOUR DEALER,
ANY CHANGE OR MODIFICATIONSTO THE EQUIPMENTBY THE USERNOT EXPRESSLYAPPROVEDBY THE
GRANTEEOR MANUFACTURERCOULD VOID THE USER'S AUTHORITYTO OPERATESUCH EQUIPMEN_
3