Manual

Setting Up a Cable Box
Press ACH+ or VCH- to select your Cable Box out-
put channel, then press OK.
If you usedan RF coaxialcableto connect the Cable Box to
the DVD Recorder (as shown on page 2 of this Guide),
choose channel 2, 3, or 4. If you used Audio andVideo
cables as shown on page 3 of this Guide, choose EXT2. If
you connected the Cable Box to other jacks of the DVD
Recorder, select EXT 1, CAM 1, or CAM 2.
Directions for connecting the G-Link cable will appear on
theTV screen If you have not connected the G-Link
cable yet, do so now. Press OK when the G-Link cable is
connected and you are ready to continue. More connection
details are on pages 2-3 of this Guide.
_f_ A list of Cable Box brands will appear. Press ACH+ or
I I VCH- to select your Cable Box brand, then press
OK. If your brand is not listed, select "Not Listed."
_ You will be advised to turn on the Cable Box and set it
_to channel 2. After doing this, press OK to continue.
_ The DVD Recorder will start testing codes,which will allow
_ the G-Link cable to change the Cable Box to channel 9. A
message will ask you to confirm whether the Cable
Box has changed to channel 9. Press ACE+ to select
Yes if the Cable Box has changed to channel 9, then
press OK.
If the Cable Box does not changeto channel 9, check all
connections.Then, press ACH+ or VCH- to select "Test
this code again,"then press OK. Or, press ACH+ or VCH-
to choose No, then press OK. The DVD Recorder will try
a different code.
Repeat this process as necessary until the Cable Box
changesto channel 9. Several codes may have to be tested
before the correct one is found.
Finalizing Setup
+® - . ,
_ The GUIDE Plus System settings will appear ( Confirming
_Your Sett ngs ). If the sett ngs are correct, press
ACH+ to choose "Yes, end setup," then press OK.
If the settings are incorrect, press VCH- to choose "No,
repeat setup process;' then press OK.You will go through
the setup screens again. Change any incorrect information.
_ Helpful information about the GUIDE Plus+_ System will
_ appear. Press OK to continue.
Another message confirming completion of setup will
lappear.You will be prompted to press OK to activate
"Watch TV." Press OK.You are finished!
Within a few seconds, the DVD Recorder will turn itself off,
then on again.
tion will be available in about 24 hours. When the
Recorder is off, channels will change on your Cable Box.
This is normal, as the unit is searching for GUIDE Plus+ _'
System information. For best results, turn off the DVD
Recorder overnight so it can receive the GUIDE Plus+_'
System programming information. Leave the Cable Box
turned on.